VMware: Sample Configuration – Network Load Balancing (NLB) Multicast mode over routed subnet – Cisco Switch Static ARP Configuration (1006525)
To configure the switch:
- Telnet in to Cisco Switch Console and log in.
- Run the following command to enter Configuration mode:
config t - STATIC ARP RESOLUTION Cisco Global command mode
For example:
arp [ip] [cluster multicast mac] ARPA
arp 192.168.1.100 03bf.c0a8.0164 ARPA - STATIC MAC RESOLUTION Cisco Global command mode
For example:
mac-address-table static [cluster multicast mac] [vlan id] [interface]
mac-address-table static 03bf.c0a8.0164 vlan 1 interface GigabitEthernet1/1 GigabitEthernet1/2
GigabitEthernet1/15 GigabitEthernet1/16
For related information, see Sample Configuration – Network Load Balancing (NLB) Multicast Mode Configuration (1006558).
Check out the complete knowledge base article after the jump
Source: | 1006525 |
I don’t even understand how I ended up right here, however I thought this submit was great. I don’t know who you are however definitely you
are going to a well-known blogger should you are not already.
Cheers!
This blog was… how do you say it? Relevant!! Finally I have found something which helped me.
Kudos!